6 Mistakes to Avoid When Installing Network Cable

Quite many times network cabling is installed inaccurately that can immobilize its performance badly, and further generate maintenance tensions, and the repair cost too can lead you to more pay. If the cabling technicians do not have a good experience in mending the cable, it may take a worst turn. Listed here are 6 mistakes that you can avoid while installing the network cable.

1. Not Utilizing Cable Management: It would be fine if you insert cable management. Including rack-based cable management and ladder rack adds more prices. But it makes continuing maintenance very simple. With more numbers of cables included, things will be modified for better. Ensure to do labeling of suitable cables, color-code cables, or else execute other distinct procedures to create it simple by spotting the cables afterwards.

2. Not Testing Cable Infrastructure: When the cable is installed properly, you need to test each and every cable that is utilizing proper tools to ensure that it will be fitting for its use that covers cable plans and verifying length that goes well with the requirements. If 1 GBps transmission speed is required by you, then you should confirm that the properties of cable will lend full support to that requirement.

3. Not Doing Planning for Future: It is up to you to consider whether you’ll stick to the past’s best cable technology, or are you set to install anything new that will get together with today’s requirements as well as yours for the upcoming years, giving you better benefits. If your company is shifting to a new location, you require installing new cabling. Though it might be a bit expensive, you should reflect upon a high-end cable for installing purpose.

4. Running the Cable near Noisy Fixtures and Devices: Loud noises can be initiated on the data cable. The bright lighting, motors, and other related items which drop magnetic or electrical hindrances will cause mess on your cable infrastructure too. While planning, ensure that you should run off a data cable way which evades such hazards.

5. Not Following Codes/Laws/Ordinances: Failing to stick to local codes that relay to low voltage cabling can bring risky problems for safety workers. In few places the PVC-jacketed cabling use is banned in air handling space. So ensure that you authenticate your tasks before you begin and also ensure that any contractors you’ve been executing with are alert of such local rules.

6. Not Minding Much about Distance Restrictions to a Certain Point:When any cabling is being run by you, the normal distinct limitation up to 1 GBps for UTP cabling is actually 100 meters. But if by chance you’re cabling for 10 GBps or 40 GBps, then you should keep in mind the distance limitations connected with the kind of cabling you aim to utilize. Take for example, if you plan of running 10 GBps up till 100 meters on twisted pair cabling, you would have to utilize Category 6A or even an appropriate cabling.

Therefore, you must have pretty well understood the above mistakes. You can also take the help of the IPGenius IT team who are always ready to help your IT Company in not making such mistakes that you may do while cable installation and support you completely.

6 Mistakes to Avoid When Installing Network Cable was last modified: June 16th, 2015 by admin